Bilge Wash
As low as
$19.00
In stock
SKU
sku
Bio-Bilge Wash is a highly concentrated biobased product which uses the power of Colloidal Chemistry to tackle the most challenging marine situations. When it is added to bilge water it emulsifies and encapsulates the floating oil or fuel.
This highly concentrated bilge wash can be used at dilution of 15:1 to 20:1.
Depending on your needs one gallon of concentrate will make from 15 to 20 gallons of usable product.
Bio-Bilge Wash is a highly concentrated biobased product which using the power of Colloidal Chemistry to tackle the most challenging marine situations. When it is added to bilge water it emulsifies and encapsulates the floating oil or fuel. Adding it to bilge/ballast water constantly cleans all contact surfaces and breaks down scum lines and other residues for safe, non-polluting disposal. Prevents slippery decks from fuel and oil residues and can be safely sprayed directly onto the surface of the water, dispersing oil and fuel and eliminating visible sheen as well as fire danger.
This product is equally effective with fresh, salt and brackish water.
CARCINOGENCITY: No ingredients lists by IARC, ACGIH, NTP or OSHA as a carcinogen.
Flash Point: None Odor: Faint odor Boiling Point: 214.4 F Freezing Point: 28.0 F Specific Gravity: 1.001 Solubility: 100% pH: 9.7 Appearance: slightly viscous
Features & Advantages
This product is ideal for:- Oil/Fuel Spill Cleanup
- Bilges and Ballast Tanks
- OPA Deck Side Emulsifier
- Fire Fighting
- Uneven platforms
- High wind/high seas applications.
Technology Highlights
This product is readily biodegradable, non-toxic, non-corrosive, non-hazardous, non-caustic, non-flammable, and hypoallergenic; it passes and exceeds the acute toxicity (LC-50) criteria adopted by the US Fish and Wildlife Service and the US EPA. It does not contain ozone depleting substances, synthetics, terpenes, petroleum distillates, glycol ethers, caustics, builders & reagents, or California Proposition 65 Chemicals. Micelles are sub-microscopic, electrically charged particles that, when activated in water, repel each other in a ceaseless random movement. Micelles in liquid solution measure sub micron in size, 50 to one hundred times smaller than the particles created from typical cleaners and detergents. This small size and their extreme surface-area-to-volume ratio enable the micelles to penetrate complex carbon molecules, and emulsify organic matter.Specifications
100% BioBased Ingredients– alkanolamines, amino acids, corn oil, nonionic surfactants, plant-based fatty acids and organic alcohol in a base of colloidal micelles. RADIOCARBON C-14 (5/10/04) USDA approved testing to meet requirements for product tested at 84 (range 83-91; N=8), Minimum biobased contact n=5. CLEAN AIR SOLVENT: SCAQMD method 313-91 NO VAHAP, ODC or GWC detected.CARCINOGENCITY: No ingredients lists by IARC, ACGIH, NTP or OSHA as a carcinogen.
Flash Point: None Odor: Faint odor Boiling Point: 214.4 F Freezing Point: 28.0 F Specific Gravity: 1.001 Solubility: 100% pH: 9.7 Appearance: slightly viscous
Suggested Dilutions
If you did not purchase the ready-to-use strength of this product, dilute as follows: Bilges (Small Craft): Use 1 quart concentrate to approximately 5 gallons of bilge water (1 to 20), or 2 oz. per 25 feet of water line. Pour solution into bilge and allow to dwell for about 1 hour while boat is running. The natural rolling action of the boat will help self-clean the bilge. Drain bilge using proper procedures, then rinse thoroughly. Oil/Fuel Spill: Dilute 15 to 1. Generously spray solution directly on spills to prevent ignition or re-ignition of fuels and oils. OPA Deck Side Emulsifier: Dilute 15 to 1. Generously spray solution directly on deck spills to eliminate oily residues and slickness. Fire Fighting: Dilute 15 to 1. Generously spray directly on fire to knockdown, emulsify and encapsulate the hydrocarbon creating a non-flammable solution. Shake well before using.Write Your Own Review